PRODUCTS
|
 |
Details
Introduction
Follow the steps in this guide to replace the volume control cable in your iPhone 6s Plus.
Remove the two 2.7 mm Phillips screws over the audio control cable bracket.
Remove the audio control cable bracket.
Disconnect the audio control flex cable from its socket on the logic board.
Remove the circular sticker covering the third screw securing the cellular antenna to the rear case.
Remove the following three Phillips screws:
One 2.7 mm screw
One 1.7 mm screw
One 1.3 mm screw
Lift, but do not remove, the cellular antenna to reveal the third screw securing the audio control cable to the rear case.
Remove the three 2.4 mm Phillips screws over the audio control cable bracket.
Use the flat end of a spudger to peel the volume control flex cable off the rear case.
Remove the volume control flex cable.
The cable assembly has two separate pieces connected by a ribbon cable—the volume control buttons and silent switch.
